
Round, square and elongated fire tables
Corten steel fire tables
Corten steel fire tables in round, square and elongated shapes.
A Corten fire table: a low table by day, a hearth after dark
Wood or bioethanol
The first decision is the fuel. Of the five tables, only Pyrros runs on bioethanol, with a line of flame down its centre that gives off neither smoke nor ash: a natural choice for a terrace opening straight off the living room. Hélios, Héphaïstos, Etna and Taranis take wood, for the crackle and glow of real embers; the first two, cut from 3 mm Corten steel, set their hearth in the middle of the top. Our fire pit or fire table guide compares the two fuels in more detail, along with the evenings each one suits.
A coffee table in daylight
Unlit, a fire table stands in for the coffee table of an outdoor lounge, so it has to look right through the long hours of the day, when its patina of rust, sienna and amber sets the tone of the terrace; the flame only takes over at nightfall. Hélios, round and 1000 or 1250 mm across, suits a circle of armchairs, and Héphaïstos comes as a square from 900 to 1600 mm or in a 1500 × 800 mm rectangular format; both stay low, at 280 mm. For a long sofa or a terrace laid out lengthwise, Etna, Taranis and Pyrros, from 1500 to 2600 mm long, run parallel to it, and Etna, with its sloping sides, carries a long line of flames.
Ground and shelter
Wherever the table goes, it stands on stone, a concrete slab or well-compacted gravel, never on anything that can burn, with the clearances set out in its instructions. Our fire tables come without varnish, so near the coast give them a sheltered spot in the lee of a wall or a hedge, away from the spray. Leave a comfortable passage all round for the seating, and keep overhanging branches and outdoor fabrics away from the flame.
FAQ
How far from the pool should a fire table stand?
Far enough that no splash can reach it. Pool water, chlorinated or from a saltwater pool, attacks the patina, and our fire tables come without varnish to protect it. If water does reach the table, rinse it with fresh water, and keep pale coping clear of run-off with a bed of gravel beneath the table rather than bare stone.
Does Pyrros give as much warmth as a wood-burning table?
No, and that is not its role. Wood gives a tall, crackling flame and radiant heat that lingers in the embers, the choice for long evenings around Hélios, Héphaïstos, Etna or Taranis. The bioethanol line of Pyrros lights instantly and gives a crisp, steady flame with a gentler, ambient warmth that suits a more architectural setting.
How is a fire table looked after between fires?
On the wood-burning models, wait until the hearth is cold before clearing the ashes, and never leave wet ash or rainwater sitting in it, since the steel needs to dry. Pyrros leaves no ash: keep its burner clean, refill it only once everything has cooled, and do not relight it the moment the flame has died. The patina itself needs nothing more.
Corten steel fire tables / The models
Our selection of Corten steel fire tables
We shape each creation by hand, with the care that your space deserves.

Round, square and elongated fire tables
The spirit of the collection
Compare the designs and check the fuel specified for each model.
Corten steel fire pit or fire table: which to choose?Cortenys
Caring for your Corten steel fire tables

01 / Advice
Plan for traffic
The balance between the hearth and the top gives the Corten fire table its furniture character. The House works on the presence of volume as much as the patina, with use in accordance with the instructions for each home. Keep passages and seats out of heat zones indicated in the instructions. The fuel and authorized uses are verified model by model. No stock of finished creations: each creation is shaped by hand after its owner's order.



02 / Advice
A creation tailored to the space
We look at your space, the setback and the access points to find the right proportions. We invite you to compare dimensions and weight on the product pages. Individuals, architects or landscapers, entrust us with the desired atmosphere and the measurements of your project to study an adaptation.

03 / Advice
Certified Corten from Italy, three weeks of hand patina
We choose authentic, certified Corten steel from Italy, far from steel with a neglected patina. We shape each creation by hand, without exception. Three weeks of hand-worked patina reveal its nuances; we stabilize it as much as possible. We find a drawing, never quite the same light.

04 / Advice
The varnish option, to support your use
Depending on the creation or your request, we provide a protective varnish to limit dripping in contact with water and patina deposits. We require this varnish for interior models. We advise you according to the exposure and the support, recommending to protect light or porous surfaces. Even varnished, Corten can leave marks.

05 / Advice
Delivery of 5 to 12 weeks
We start after your order. We do not stock any finished creations: prolonged storage in closed packaging harms their patina. We deliver 5 to 12 weeks after confirmation, combining shaping, patina, rest, checks, hand packaging and transport. We invite you to prepare suitable access and handling means.

06 / Advice
The demands of the House, even in the service
We look at Corten like a new gold: its depth, its light and the time of our hands make its value. We are a House, not a factory. We may refuse a request to avoid overproduction and maintain care for each creation. We support you in the choice, the preparation of its arrival and after its delivery, with the same attention.
07 / Cortenys
Fire at the heart of the outdoor lounge
Around Hélios, a round fire table in 3 mm Corten steel, the seats fall naturally into place: no corners, no head of the table, everyone faces the flame.
08 / Cortenys
By the water, two ways of drawing fire
Taranis sets a round hearth at the end of a long top and leaves the rest to the table; Pyrros draws a line of bioethanol flame down the middle of a Corten steel slab.
09 / Cortenys
A line of embers facing the landscape
With its sloping sides, the Etna fire table stretches a long wood-burning hearth along almost its entire length, in three lengths made to order.
10 / Cortenys
The square, for generous gatherings
Héphaïstos, a crisp-edged monolith of Corten steel, sets its hearth at the heart of the block. Seven formats, from a 900 mm square to the rectangular version.

Corten steel fire tables / Perspectives
In their setting.
Made to order
The time each piece deserves.
We shape each creation by hand, without exception, after your order. No stock: storage in closed packaging harms the patina. We devote 5 to 12 weeks to artisanal work and care.
5 to 12 weeks
Preparation
Included in the total lead time
We check configuration, dimensions and delivery. For Corten, we choose an authentic material certified from Italy.
Making
Included in the total lead time
We shape each creation by hand, without exception. We take care of the folds, welds and adjustments to give the design its clean lines and precise assemblies.
Cortenys signature patina
three weeks
We work the Corten patina by hand over three weeks. Between each stage and period of rest, we return to its shades, then stabilise it as far as possible. Depending on the piece or your request, we provide a protective varnish to limit runoff when the metal meets water. We require varnish indoors and recommend protecting pale or porous surfaces.
Delivery
Included in the total lead time
We check and then package each creation by hand. We adapt its protections to transport to preserve angles and surfaces, avoiding trapping humidity against the patina.
We develop the Corten patina by hand over three weeks, within the overall delivery window of 5 to 12 weeks. We allow the material to rest, inspect it and prepare it carefully for its journey.
Cortenys
Corten steel fire tables: frequently asked questions
What is a Corten steel fire table?
It is a hearth set into a tabletop, sometimes called a fire pit table: you sit around it as you would around a table, and enjoy the flame from your chair. Where a fire pit is there to be gazed at, a fire table is there to be shared.
What formats are available?
We present dimensions and options on each product sheet. We study any bespoke format before committing.
Can Corten stain the floor?
We stabilize the patina as much as possible. Depending on the creation or your request, we offer a varnish to limit drips in contact with water, without excluding them. We recommend protecting light or porous floors with spacers, gravel or a saucer.
How to prepare for delivery?
We deliver 5 to 12 weeks after confirmation. We invite you to check access and handling, then unpack and check the creation upon receipt. In case of damage, send us photos of the creation and packaging with your order reference.
Which finish to choose for Corten?
We develop the Corten patina by hand over three weeks. Depending on the creation or your request, a protective varnish limits drips without excluding them. We require this varnish for indoor use and recommend protection of sensitive surfaces.
A particular project in mind?
We study your space, its dimensions and its finish. We select projects to which we can give our full attention.
Cortenys collections




